Steam Proofing Your Steam Shower Room

The steam shower is a great means for anybody to relax their tired body right after a long tough day. A steam generator squeezes clouds of vapor into a shower room and so this steam reinvigorates your body leaving behind your body comfortable and feeling like new. The only method that this could occur is when the shower cabin enclosure is correctly sealed in order that it enables an accumulation of vapor inside the stall. If the cabin is not correctly sealed then all of the steam will simply keep getting away and then the buildup will not be attained. This is why you should steam proof the room properly.

opus shower curtainFirst thing that you have to do is to make sure that the roof on the steam cabin is set up at an angle. The most common mistake plenty of people do in setting up the roof of the stall is to do this completely horizontal. The issue with not positioning the ceiling at an angle is that as the vapor comes up into the roof, it will condense on the ceiling. This condensed water will likely then fall down cold onto your shoulders destroying the whole spa-experience.

What you should do next is to take care of the wood framing. These must be protected in order that they don’t decay as time passes creating unneeded complications. An easy solution would be to cover it with some sheets of plastic ideally 6-mil. You must make certain that they’re affixed all over the joists and studs. The plastic material has to overlap all of the frames edges by at least 1 foot.

There are a few seams which you will find in the center of the concrete backer-board panels. With any luck, moisture will still not influence them. Seal them off with mesh tape and also put a little thinset.

The next step that you want to take care of is waterproofing the whole backer board. You cannot leave behind even one inch undone. There are 2 things that you can select from to do the waterproofing. You can obtain a roll-on LIQUID polymer. There are several kinds you could select. You’ll need to apply 2 coats which will finish up drying out into something which appears like a rubber. It will have no seams and nowhere for water to pass through. Laticrete’s Hydro-Ban is an excellent one to utilize. The other choice is to have clustered polyethylene. A great choice would be the Kerdi Membrane which is easily found created by Schutler systems. To seal off the particular back boarder, you will then have to embed those sheets right into some wet thinset.

You then want to start tiling as you normally would. If you have opted that you are going to utilize stone, you will need to go the extra mile and start adding some impregnator to make certain that it’s totally covered off. You will need to do that regularly in ranges of each and every two years.

Last but not least, you want to make sure that all of the fixtures that come from the stone or tile are also sealed off. You can use O-rings or gaskets to do this.
This page was provided by our good friends over at www.aqualussoshowers.co.uk, the official outlet for aqualusso showers

Related Post

Leave a Reply